Magnet Mount Nori Clip

This clip holds a sheet of dried algae in your tank. Two slots run down the face of the plate. Thread the sheet down one slot and back up the other, so it weaves through the plate. The slots measure 2.2mm at the top and narrow to 1.4mm at the floor, so a folded sheet wedges in. We have not tested how well it grips, so check it yourself before you rely on it. A pocket on the back takes one 12mm by 3mm disc magnet. The pocket is closed on every side, so the magnet sits inside the print and never touches the water. You need two magnets, one for the pocket and one for the dry side of the glass. Magnets are not included, and we do not publish a hold figure. We print in PETG. Aquarium keepers have used it submerged for years. Rinse before use.

This is a new product. We print-test every part before it ships.

One piece design

$11.99

Pieces: 1
Material: PETG

Color: Black

Made in the USA. Printed in the USA when you order.

Made in the USA
Printed to order
Custom sized

Fitment

This part fits the size named in its description above. That size comes from the maker’s own listing. We do not guess a dimension we have not sourced.

Safety

A note on safety

We print every part in PETG. It is the material aquarium keepers have used submerged for years. We cannot promise how any part performs in your tank. You know your tank and your animals best, so the call is always yours. Rinse each part in clean water before you add it to your tank.