Saltwater Aquarium Parts
Adapters, intake guards, and mounts, sized for saltwater tanks that keep marine fish and inverts.
13 parts made for saltwater tanks.
Saltwater tanks run different gear than freshwater setups, from powerheads to ATO sensors. Below are adapters, guards, and mounts sized for marine fish only tanks. Pick a category to see every size we make.
Adapters
Connect a canister hose to vinyl tubing or another hose size. Push-on fit, no glue.
Elbow Adapters
Two piece, 90 degree adapters for tight spots behind the tank.
Fish Guards
Wide-slot intake cages for fish tanks, a 4.0mm slot, wider than our shrimp guards.
Heater Guards
Slotted cages that close around a round heater body. Built in segments, so you set the length.
Powerhead Guards
Slotted cages that slip over a reef pump to keep fish and critters out.
ATO Sensor Mounts
Brackets that hold an ATO sensor or a threaded float switch at the height you set. Built for the Neptune OS-1 and for M16 and M10 float switches.
Probe and Equipment Mounts
Printed clips and brackets that hold a probe, a controller, or a heater where you want it. Keyed to a 12mm probe and to named gear.
UV Sterilizer Mounts
Two piece PETG clamps that hold an inline UV sterilizer against the cabinet.
Sump Media Baskets
Open media baskets sized for a standard quarter inch glass sump chamber.
Filter Sock Holders
Cups that hold filter floss or media in a reef tank back chamber.
Sump Baffle Clips
U channels that silicone into a sump and hold a baffle panel square. Cut for 1/4 inch and 3/8 inch panels, with a corner version too.
Light Shades
Printed skirts that block glare and stop light spilling into the room, shaped to popular reef LED fixtures.
Feeding Rings and Nori Clips
Rings that wall off a patch of the water surface for food, plus clips that hold a sheet of dried algae. Magnet pocket or rim clip.
Not sure which part fits your saltwater tank?
Tell us what you have on one end and what you want on the other. We will show you the part built for those two sizes.
Find your fit