Real photo of the Black part.
Inline UV Sterilizer Mount, 3 Inch Body (Two-Piece)
This is a two piece clamp that holds an inline UV sterilizer against your cabinet wall. It fits a UV body about 3 inch across. The two halves wrap around the body and bolt together, and a back plate screws to the wall or the cabinet side. We print it in PETG. That is stronger than the PLA plastic most of these clamps are made from, so it holds up better in a damp cabinet. These clamps also suit the small inline UV clarifiers used on ponds and water features, for a shaded, covered, or submerged spot, and the same clamps suit inline UV units on indoor hydroponic and aquaponic reservoirs. Keep it out of direct sun, since sun wears down any plastic over time. Bolts and screws are not included.
Made in the USA
Printed to order
Custom sized
Need help identifying your setup? Send us a photo.
Snap the label on your gear and the spot the part goes. A person looks at every photo and emails you back.
Send a photoSpecifications and install steps
Specifications
- Material
- PETG
- Colors
- Black, White, Orange
- Pieces included
- 2 printed pieces that fit together
- Care
- It sits on the dry side, so it does not need a rinse. Keep it out of direct sun, since sun wears down any plastic over time.
Need a different size?
Pick your sizes in the Custom Builder and we will print it.
Build a custom partHow to put this UV mount up
- What is in the box
- 2 printed pieces. The pieces are the halves of the clamp and the back plate. Bolts and screws are not included, so use your own hardware sized to the mount's holes.
- How it goes on
- The two halves wrap around the sterilizer body and bolt together.
- The back plate screws to the cabinet wall or the cabinet side.
- The mount clamps around the outside of the body. It stays on the dry side and never touches your tank water.
- Check it the first time
- Check your own bolts and screws are snug before you let go of the sterilizer.
- Cleaning
- It sits on the dry side, so it does not need a rinse. Keep it out of direct sun, since sun wears down any plastic over time.
- Taking it off
- Undo your own bolts and screws and lift it away.
Safety
A note on safety
We print every part in PETG. It is the material aquarium keepers have used submerged for years. Rinse each part in clean water before you add it to your tank.
Common questions
How does the UV mount attach to my sterilizer?
Two halves bolt around the sterilizer body, and a back plate screws to the cabinet wall. You supply the bolts and screws.
Why is the mount printed in PETG instead of PLA?
PETG holds up better than PLA in a damp cabinet. A UV sterilizer cabinet sees splashes and humidity, so we chose the sturdier plastic.
Do bolts and screws come with the mount?
No. Bolts and screws are not included, so use your own hardware sized to the mount's holes.
Will the mount fit any inline UV sterilizer?
It is sized to the sterilizer body named on the product page. That page lists the body size each mount takes.