Sump Baffle Corner Clip for 1/4 Inch Panel
This corner clip is two channels that meet at a right angle, for a baffle panel that lands in a sump corner. Both channels are cut for a 1/4 inch panel, about 6.35mm. Glue the clip to the sump floor or wall with aquarium silicone. Once it cures, slide the panel down into the channel. The clip holds the panel square, so it does not lean or drift while you work. Sheet glass and acrylic often run a little thinner than the size on the label, and most sumps are built by hand. Measure your panel and check the fit before you glue anything down. Most sumps need more than one clip. Plan on a clip at each end of every panel. We print in PETG. Aquarium keepers have used it submerged for years. Rinse before use.
This is a new product. We print-test every part before it ships.
One piece design
- Pieces
- 1
- Material
- PETG
Made in the USA. Printed in the USA when you order.
Fill a rack or a fish room? Buy more and pay less per piece.
Need more than 25? Ask for a bulk price.
Made in the USA
Printed to order
Custom sized
Fitment
Safety
A note on safety
We print every part in PETG. It is the material aquarium keepers have used submerged for years. We cannot promise how any part performs in your tank. You know your tank and your animals best, so the call is always yours. Rinse each part in clean water before you add it to your tank.