Real photo of the Black part.
Aquarium Heater Clip for a 3/4 Inch Heater
This clip fits a 3/4 inch aquarium heater body, about 19mm across. It grips the heater body and hooks over your tank or sump wall, so the heater stays where you set it. Clip it around the cool top collar of the heater, above the heating element. Never clip the hot middle of the glass. Heat that high softens any printed plastic, so the top collar is the only safe spot for this clip. We print in PETG. Aquarium keepers have used it submerged for years. Rinse before use.
This is a new product.
One piece design
Made in the USA
Printed to order
Custom sized
Need help identifying your setup? Send us a photo.
Snap the label on your gear and the spot the part goes. A person looks at every photo and emails you back.
Send a photoSpecifications and install steps
Specifications
- Material
- PETG
- Colors
- Black, White
- Pieces included
- 1 printed piece
Need a different size?
Pick your sizes in the Custom Builder and we will print it.
Build a custom partSafety
A note on safety
We print every part in PETG. It is the material aquarium keepers have used submerged for years. Rinse each part in clean water before you add it to your tank.
Common questions
Which mount do I need: probe clip, controller bracket, or heater clip?
Pick the probe clip for a pH, ORP, or temperature probe. Pick the controller bracket to hold a controller box in place. Pick the heater clip to hold your heater steady in the tank.
Does the probe clip fit any brand of probe?
It is made for a 12mm probe, the size most pH, ORP, and temperature probes use. A universal clip covers probes from 10mm to 24mm.
How do I attach these mounts?
Push each part on by hand. No glue or tools are needed.
Which part of my heater should the clip hold?
Clip it by the cool top collar, never by the hot glass near the element.