Real photo of the Black part.
Lily Pipe Holder, 17mm Pipe
This holder clamps over your tank wall and grips a lily pipe. It fits a 17mm pipe, in glass, acrylic, or PETG. That is the same size Aquario Neo and ADA pipes use. The rim clamp opens wide, so it fits a wall up to about 12mm thick. Turn a nylon thumb screw to snug it down on any wall inside that range. Soft plastic will not scratch the glass the way a metal clip can. PETG is a strong pick for a wet spot like a tank rim. Screws are not included. Rinse before use.
One piece design
Made in the USA
Printed to order
Custom sized
Need help identifying your setup? Send us a photo.
Snap the label on your gear and the spot the part goes. A person looks at every photo and emails you back.
Send a photoSpecifications and install steps
Specifications
- Material
- PETG
- Colors
- Black, White
- Pieces included
- 1 printed piece
- Care
- Take it off the rim and rinse it in clean water.
Need a different size?
Pick your sizes in the Custom Builder and we will print it.
Build a custom partHow to put this lily pipe holder up
- What is in the box
- One printed piece. The thumb screw is not included.
- How it goes on
- The clip end grips the lily pipe. The clamp end goes over your tank wall.
- Open the clamp over the rim. It fits a wall up to about 12mm thick, and the thumb screw takes up the slack on a thinner rim.
- Turn the nylon thumb screw by hand to snug it down. Do not use a tool.
- Set the pipe into the clip. It grips a 13mm or a 17mm pipe, so check your own pipe against the size on this page.
- Check it the first time
- Rinse the part in clean water before it goes in your tank.
- Check the seat once it is holding the pipe.
- Cleaning
- Take it off the rim and rinse it in clean water.
- Taking it off
- Back the thumb screw off and lift it away.
Safety
A note on safety
We print every part in PETG. It is the material aquarium keepers have used submerged for years. Rinse each part in clean water before you add it to your tank.
Common questions
What size lily pipe does the holder fit?
The rim clip grips a 13mm or 17mm lily pipe. Pick the option that matches the outside size of your pipe.
How thick a tank wall does the clamp fit?
The rim clamp opens to fit a tank wall up to about 12mm thick, and a thumb screw takes up the slack on anything thinner.
Will the clamp scratch my tank glass?
The clamp is smooth printed PETG, and a thumb screw snugs it down on the rim. Turn the screw by hand, not with a tool, and check the seat now and then like any rim gear.
Can I use the holder on a lily pipe I did not buy from TankRig?
Yes, as long as the pipe's outside size is the 13mm or 17mm the clip grips.