ATO Sensor Wall Bracket for the Neptune OS-1

This bracket holds the Neptune OS-1 ATO sensor. The OS-1 body measures 12.70mm across. A C shaped channel runs down the bracket. Push the sensor in through the side mouth and slide it up or down to set the level you want. The channel holds 22mm of the body at any height, with 30mm of travel. Two full length rails on the back stand the bracket off a cabinet wall, a sump baffle, or an overflow face, so there is room for the cable behind it. Two screw holes run through the rails. Pick screws that suit your own wall. Screws are not included. These sensors need a different mount. The AutoAqua Smart ATO Micro, Lite G2, and nano are square. The Innovative Marine HydroFill and HydroFill Ti are flat blocks. The XP Aqua Duetto 2 puts two sensors in one housing. The Red Sea ReefATO+ comes on its own magnet bracket. The Tunze 3152.300 and the CoralVue HYDROS float are not covered either. This is a bracket. It holds a sensor at the height you set. This part stays dry in the cabinet. We print it in PETG, a tough plastic. Keep it out of direct sun, since sun wears down any plastic over time.

This is a new product.