Dosing Bottle Holder, 110 mm Round, Two Bay Modular

This holder stands your dosing containers upright in your cabinet. Each bay is cut for a round bottle 110mm across and 188mm tall. Bottles like these are molded, so they run a little out of round, they flex when they are full, and most carry a wrap label that nobody measures. So the bay is cut loose on purpose. Measure your own bottle before you order. We found this size on a maker's page that would not load again for us, so we hold it as a listing and not a spec. Treat it as a starting point, not a hard fit. The body is a shell, not a block, and the top of each wall is cut into fingers, so you can still read the label and the dose marks. The floor is three bars with drain gaps between them. It is open, so nothing is caught or held there. We make no claim about spills or drips. A 6mm hole beside each bay lets a dosing line pass through. It is a plain 6mm hole, not a fit for any named tubing. This ships as two pieces, one bay each. A dovetail on one edge slides down into a socket on the next, so the pieces lock side by side into one tray, and the tray grows as your dosing schedule does. Lower each piece onto the last from above. That joint is our own design and it has not been printed and hand fitted yet, so check it when it arrives. This holder sits in the cabinet and stays dry. We print it in PETG, a tough plastic. Keep it out of direct sun, since sun wears down any plastic over time.

This is a new product. We print-test every part before it ships.

• Made in the USA
• Printed to order
• Custom sized