Dosing Container Holder, 192 x 140 mm Rectangular Pocket, Single Bay

This holder stands a dosing container upright in your cabinet. The pocket is cut for a flat sided container 192mm by 140mm and 312mm tall. Containers like these are molded, so their sides bow a little, they flex when they are full, and most carry a wrap label that nobody measures. So the pocket is cut loose on purpose. Measure your own container before you order. We found this size on one overseas shop listing and could not fetch the page again to check it. Treat it as a starting point, not a hard fit. The body is a shell, not a block, and the top of each wall is cut into fingers, so you can still read the label and the dose marks. The floor is three bars with drain gaps between them. It is open, so nothing is caught or held there. We make no claim about spills or drips. A 6mm hole beside each bay lets a dosing line pass through. It is a plain 6mm hole, not a fit for any named tubing. This is one piece with one bay. At this container size only one pocket fits on a print bed, so this holder is a single pocket. This holder sits in the cabinet and stays dry. We print it in PETG, a tough plastic. Keep it out of direct sun, since sun wears down any plastic over time.

This is a new product. We print-test every part before it ships.

• Made in the USA
• Printed to order
• Custom sized