Dosing Bottle Holder, 62 mm Round, Two Bay, Wall Mount with Strap Band

This holder stands your dosing containers upright in your cabinet. Each bay is cut for a round bottle 62mm across and 198mm tall. Bottles like these are molded, so they run a little out of round, they flex when they are full, and most carry a wrap label that nobody measures. So the bay is cut loose on purpose. Measure your own bottle before you order. The body is a shell, not a block, and the top of each wall is cut into fingers, so you can still read the label and the dose marks. The floor is three bars with drain gaps between them. It is open, so nothing is caught or held there. We make no claim about spills or drips. A 6mm hole beside each bay lets a dosing line pass through. It is a plain 6mm hole, not a fit for any named tubing. This is one piece with two bays. A plate on the back screws to your cabinet wall. The screw hole is a 4.5mm clearance hole for a common number 8 wood screw. Screws are not included. We give no weight rating, and we do not tell you which wall or which fastener is right for your cabinet. That part is your call. A tall back wall carries two slots per bay for your own strap. Each slot measures 20mm by 4mm, sized for a 3/4 inch hook and loop strap or a heavy cable tie. Run the strap out one slot, around the container, and back in the other. This container is tall for the size of its base, which is why the band is there. The strap is not included. This holder sits in the cabinet and stays dry. We print it in PETG, a tough plastic. Keep it out of direct sun, since sun wears down any plastic over time.

This is a new product. We print-test every part before it ships.

• Made in the USA
• Printed to order
• Custom sized